It's JAZZ released in Europe.

A photograph is completely together with a mother's Fit by chance.

This side winker was mimicked.

Side winker made by HELLA.

There were three kinds of modern type winkers that I knew.
The shape of the lens is the same, and shape in the base part is different.
The one of a short type is selected most in three kinds of.

Two orange electric bulbs are included.
By the way, it was 3600 Yen.

First of all, it makes with cardboard the type of the installation hole of the winker.
Put on the body side and the installation hole is written, and it stuck so that a edge might be traced by packing tape made of cloth.
Of course, a size is firmly measured also with right and left, and it positions.
Then boldly open the hole on the body with the drill .
In the size that the blade of iron saw enters .
At this time, A body will be distorted if it is just before the outline of a winker hole .

Makes to rasp the hole edge .

It takes time to do this though the iron plate of the body is thin .
Then, so as not to rust, the edge was clearly painted .

The base part of the winker was painted on the same color as the body .

but oops ,,, the crack has entered the part in the verge of the lens and the base .
Shrinking slightly when paints dried might have influenced it .
anyway, Let's assume it is good because it doesn't understand as long as it doesn't gaze .

It is a socket of this winker .

The sockets are not attached to the bought winker .
When asking to sell only the socket in the shop, Frankly it was said that it would give it because it remained.

Of course, it is a winker socket for VW, so it's fit in this winkers .

Wiring is soldered with the socket .

Though wiring was going to have been installed for myself considerably long, length was just when actually installing it .
By the way, I think that it was about 70cm .

When length was insufficient, it became considerably plain because of addition .

A little more below though will have set to the winker position of JAZZ .
Though it is now slow already . (^o^)
The front position light were incidentally replaced with an existing winker .
And because the socket is the same shape, an existing winker and the front position light can be replaced as it is .
The lamp is not installed in an of course existing winker socket .

Whatta 1280 Yen !. (A famous manufacturer is about 5000 yen.)
Though the manufacturer name is unnamed .
If it is Kohnan etc. , it sells it also in the minor manufacturer though only a famous manufacturer seems to be selling in the car articles shop such as Autobacs .
It's 110/120W, and color temperature is 3900K, and the car inspection correspondences .
White beam that is unlimited and near the sun light .
The relay harness is unnecessary, and because brightness in the ratings power consumption has improved, it is only a valve exchange and OK .
It is not anxious even if it breaks if it is such cheap .

Normal .
Seemingly it is yellow too. 
.
.

After .
It is quite whitish .
The front position light is being replaced with the existing winker part.