Brake lamp socket for FIT.
(I think that these parts are common parts with another model. )

Parts number is "33513-SAA-003".
400 Yen per piece.
2 pieces were bought and 800 Yen in Total.

* Please check the parts number again.

Single parts were not able to order though it was asked whether the connector was able to be ordered because it stuck to Wire Assy.

Although I asked whether there would be any junk parts, but there are few Wire defects itself, this is also NG.

In Solder which I have, it was too large and was not able to apply solder to a socket.
so, used mediocre terminals.

Buys it at Nipponbashi. (The Otaku town in Japan)
It was selling from one piece.
Maybe, the price was about 5 Yen a piece.

As for using electric bulb, two filaments are contained.
The price was 340 Yen in the pair.

Same capacity as normality by 12V 21W/5W.

There are 3 pins of the socket.
Uses it by three a couple by Brake lamp line, Small lamp line, and GND line.

Attention coz the electric bulb got considerably hot.

Rear bumper is
A : plus screw
B : 5mm hexagon head bolt (hex-head wrench)
C : Clips

The hole which newly inserts a socket in the part of an arrow made.

Although at least the diameter of 20mm is good, it opens somewhat more smallish and the way with slight accuracy is safe in entering condition gradually.

Inserting a socket also made the key slot to the trial, although fixed firmly.
Although a slot was not able to be made finely, it was fixable firmly.

Inside rubbish was able to be exhausted firmly by it was washing and dryness though a lot of rubbishs entered the lens.
Rubbish is OK even if it sucks it out with the cleaner.

Diverges from the wiring for the normal brake lamp by using the Electro-Tap.

Whether the Small lamp and Brake lamp lights respectively is checked and the end.